skip to main text

Placing Printable Nail Stickers

To print onto Printable Nail Stickers, place them on the multi-purpose tray supplied with the printer, and then insert them into the printer.

Important

  • Do not mount the multi-purpose tray until the message prompting you to load Printable Nail Stickers appears. Doing so can damage the printer.

  1. Take out multi-purpose tray from multi-purpose tray storage compartment.

  2. Open the paper output tray (A) gently.

  3. When message prompting you to load Printable Nail Stickers appears, open the multi-purpose tray guide (B).

  4. Place Printable Nail Stickers on multi-purpose tray.

    Important

    • Check that there is no dirt on the multi-purpose tray before placing Printable Nail Stickers on it.

    • To prevent getting dirt or fingerprints on Printable Nail Stickers, hold the stickers by their edges. If the print side gets any dirt or is damaged, it may cause poor print quality.

    • When placing Printable Nail Stickers on the multi-purpose tray, do not touch the reflectors (C) on the multi-purpose tray.

    1. WITH PRINT SIDE FACING UP, place Printable Nail Stickers and press it against lock (D) at bottom.

    2. While pressing down lock with Printable Nail Stickers, insert two tabs (E) on top into slits (F) on multi-purpose tray.

  5. Place multi-purpose tray on multi-purpose tray guide.

  6. Insert multi-purpose tray straight in in horizontal direction until arrow () on multi-purpose tray guide is approximately aligned with arrow () on multi-purpose tray.

    Important

    • Do not insert the multi-purpose tray beyond the arrow () on the multi-purpose tray guide.

Note

  • The multi-purpose tray may be ejected after a certain amount of time passes. In such a case, follow the on-screen instructions to place the multi-purpose tray again.